Poly Small Room Kit with Poly Studio R30 and HP PC
See the Regulatory Notices for all regulatory and safety guidance prior to configuration.
Avant de procéder à la configuration, veuillez consulter les Avis de réglementation, afin de prendre connaissance des recommandations en matière de sécurité et de réglementation.
Get Started
Before you begin, make sure that you have the following:
•
Display HDMI cable(s)
•
Phillips #1 screwdriver and flathead screwdriver
•
(Optional) EDID emulator (see step 7)
Unpack the Poly Studio R30, Poly GC8, HP PC, and 10 m USB-A to USB-C cable from their boxes. Note that the HP PC is shipped separately.
Page 1
Phillips #1 screwdriver and flathead screwdriver • (Optional) EDID emulator (see step 7) Unpack the Poly Studio R30, Poly GC8, HP PC, and 10 m USB-A to USB-C cable from their boxes. Note that the HP PC is shipped separately. poly.com/setup/poly-room-kits 3725-13661-001A...
Page 2
1. Remove the bottom panel from the Poly GC8: loosen the screw with a Phillips #1 11. Plug in and power on the Poly GC8 and then plug in and power on the other screwdriver, turn the GC8 faceup, press the rubber circles on each side, and slide the components.
Need help?
Do you have a question about the R30 and is the answer not in the manual?
Questions and answers