General Information; Safety Instructions - Hilti PR 300-HV2 Operating Instructions Manual

1 General information

1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
en
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
1.2 Explanation of the pictograms and other
information
Symbols
Read the General
operating warning
instructions
before use.
For indoor Return
use only materials for
recycling
Locked

2 Safety instructions

2.1 Basic information concerning safety
In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
2.2 General safety rules
a) Do not render safety devices ineffective and do
not remove information and warning notices.
b) Modification of the tool is not permissible.
26
Warning: Warning:
caustic electricity
substances
Do not look Warning:
into the explosive
beam. substances
Unlocked
On the tool
Laser Class 2 product. Do not stare into the beam.
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
c) Stay alert, watch what you are doing and use
common sense when operating the tool. Don't
use the tool when you are tired or under the influ-
ence of drugs, alcohol or medication. A moment of
inattention while operating tools may result in serious
personal injury.
d) Keep laser tools out of reach of children.
e) Failure to follow the correct procedures when open-
ing the tool may cause emission of laser radiation in
excess of class 2 or, respectively, class 3. Have the
tool repaired only at a Hilti service center.