Advertisement
3
Installing the Front
Mounting Tubes
Parts needed for this procedure:
2
Front mounting tube
2
Flange-head bolt (5/16 x 3 inches)
2
Spacer (5/8 x 1 inch)
4
Flange nut (5/16 inch)
2
Carriage bolt (5/16 x 2 inches)
Procedure
Loosely install the 2 front mounting tubes using 2
flange-head bolts (5/16 x 3 inches), 2 spacers (5/8 x 1
inch), 4 flange nuts (5/16 inch), and 2 carriage bolts
(5/16 x 2 inches) as shown in
Left side shown
1. Flange nut (5/16 inch)
2. Front mounting tube
3. Flange-head bolt (5/16 x 3
inches)
Figure
3.
Figure 3
4. Carriage bolt (5/16 x 2
inches)
5. Spacer (5/8 x 1 inch)
4
Removing the Side Panels
No Parts Required
For Gasoline Machines
Important:
Before performing this procedure,
check your machine to see if the holes for
installation already exist. If not, proceed with this
procedure.
Note:
Retain all the hardware that you remove in this
procedure.
1.
Remove the flange-head bolt securing the fuel
tank to the tank tray
1. Fuel tank
2. Screw
3. Hold-down
g268153
2.
Remove the screws securing the hold-down
(Figure
4).
2
(Figure
4).
Figure 4
4. Fuel line
5. Vent hose
6. Flange-head bolt
g033946
Advertisement
