Advertisement
7
Installing the Rear
Mounting Tubes and
Tube-Mounting Bracket
Parts needed for this procedure:
2
Rear mounting tube
1
Tube-mounting bracket
2
Flange-head bolt (5/16 x 3 inches)
2
Flange nut (5/16 inch)
2
Flange-head bolt (3/8 x 1-3/4 inches)
2
Flange-head bolt (3/8 x 3-1/2 inches)
4
Locknut (3/8 inch)
1
Trim seal
Procedure
1.
Loosely install the 2 rear mounting tubes using
2 flange-head bolts (3/8 x 3-1/2 inches), 2
flange-head bolts (3/8 x 1-3/4 inches), and 4
locknuts (3/8 inch) as shown in
Figure 12
Left side shown
1. Rear mounting tube
2. Locknut (3/8 inch)
Figure
12.
g261071
3. Flange-head bolt (3/8 x
1-3/4 inches)
4. Flange-head bolt (3/8 x
3-1/2 inches)
2.
Secure the tube-mounting bracket to the rear
mounting tubes using 2 flange-head bolts (5/16
x 3 inches) and 2 flange nuts (5/16 inch) as
shown in
Figure
3.
Install the trim seal onto the tube-mounting
bracket
(Figure
1. Trim seal
2. Flange nut (5/16 inch)
4.
Tighten the fasteners installed in step 1.
Torque the 5/16-inch fasteners to 20 to 25 N∙m
(175 to 225 in-lb).
Torque the 3/8-inch fasteners to 37 to 45 N∙m
(27 to 33 ft-lb).
7
13.
13).
Figure 13
3. Flange-head bolt (5/16 x 3
inches)
4. Tube-mounting bracket
g259788
Advertisement
