Installing The Side Panels - Toro 07320 Installation Instructions Manual

1. Bolt (5/16 inch)
2. Bolt (3/8 x 7/8 inch)
3. Washer
4. Nut (5/16 inch)
2. Torque the 2 bolts (3/8 x 7/8 inch) and 4 bolts
(3/8 x 1 inch) to 37 to 45 N∙-m (27 to 33 ft-lb).
3. Torque the 2 bolts (5/16 inch) to 1978 to 2543
N∙cm (175 to 225 in-lb).
8
Installing the Cab Frame
Parts needed for this procedure:
1 Cab frame
4 Bolts (3/8 x 7/8 inch)
10 Bolt (3/8 x 3/4 inch)
10 Nuts (3/8 inch)
Procedure
1. Lift the cab frame using the lifting points and
place it on the machine
1. Lifting points
Figure 4
5. Nut (3/8 inch)
6. Bolt (3/8 x 1 inch)
7. Nut (3/8 inch)
(Figure 5).
Figure 5
2. Secure the frame to the machine using 10 bolts
(3/8 x 3/4 inch), 10 nuts (3/8 inch), and 4 bolts
(3/8 x 7/8 inch) as shown in
g026277
1. Bolt (3/8 x 7/8 inch)
3. Torque the bolts to 37 to 45 N∙m (27 to 33 ft-lb).
9

Installing the Side Panels

Parts needed for this procedure:
2 Side-plate panels
4 Bolts (1/4 inch)
2 Side-plate foam panel
Procedure
1. Fasten the mounting plates onto the cab using 4
bolts (1/4 inch) as shown in
2. Torque the bolts to 1017 to 1243 N∙cm (90 to
110 in-lb).
3. Remove the paper backing from the double stick
tape on the mounting plates
g026497
8
Figure 6.
Figure 6
Figure 7.
(Figure 7).
g026425