Selecting A Base Unit; Nn47200-300 04.03 13 April; Selecting A Base Unit Using The Ui Button - Nortel BayStack 5520-48T-PWR Install Manual

92 Procedures for installation of the switch
Figure 23
Cascade down stack configuration

Selecting a base unit

This procedure describes the steps to select a base unit.
Procedure Steps
Step
1
2
3

Selecting a base unit using the UI button

This procedure describes the steps necessary to set the base unit using
the UI button.
Copyright © 2008–2009 Nortel Networks
Action
Determine which unit will be the base unit.
Locate the Unit Select switch on the rear panel.
Slide the switch to the right to designate it as the base unit.
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
--End--