Ers 5000 Series Installation - Nortel BayStack 5520-48T-PWR Install Manual

78 Procedures for installation of the switch
Procedure Steps
Step
1
Table 10
Job aid: Switch LED state indicators
Label
UI button
Pwr
Status
Copyright © 2008–2009 Nortel Networks
Action
To check and interpret front panel LEDs, compare the LEDs to
the tables in the Job Aids section.
Color / Status
White/steady
Off
Green / steady
Green / blinking
Amber / slow
blinking
Amber / fast
blinking
Off
Green / steady
Green / blinking
Amber / steady

ERS 5000 Series Installation

NN47200-300 04.03
13 April 2009
--End--
Description
Power is on.
Power is off.
The switch is connected to AC power and is
receiving power.
Problem with primary Boot image. Booted from
back up image. Configuration and agent code
may be incorrect.
System will reset in less than 3 seconds. To
stop the reset, release UI push button.
System will reset in less than 1 second. To
stop the reset, release UI push button.
The switch is not connected to an AC power
source or the power supply unit is not
supplying power.
•
During Initialization: The power-on
self-test is complete and the switch is
operating normally.
•
After Initialization: The front panel
configuration mode is inactive. Unit booted
successfully.
•
During Initialization:: A non-fatal error
occurred during the self-test.
•
After Initialization: The user pushed the
UI button and activated the front panel
configuration mode and the system is
awaiting input.
•
During Initialization: N/A
•
After Initialization: The front panel has
accepted the user command. The system