Table of Contents
Advertisement
USING THE PROJECTOR
Setup menu
Projection menu
Projection
Select the preferred projection between front, rear, ceiling-top, and rear-top.
Power settings menu
Direct Power On
Choose "On" to activate Direct Power mode. The projector will automatically power on when AC power is supplied,
without pressing the "Power" key on the projector keypad or on the remote control.
Signal Power On
Choose "On" to activate Signal Power mode. The projector will automatically power on when a signal is detected,
without pressing the "Power" key on the projector Keypad or on the remote control.
Note:
‡
If the "Signal Power On" option is turned "On", the power consumption of the projector in standby
mode will be over 3W.
‡
This function is applicable with VGA and HDMI sources.
Auto Power Off (min.)
Sets the countdown timer interval. The countdown timer will start, when there is no signal being sent to the
projector. The projector will automatically power off when the countdown has finished (in minutes).
Sleep Timer (min.)
Configure the sleep timer.
‡
Sleep Timer (min.): Sets the countdown timer interval. The countdown timer will start, with or without
a signal being sent to the projector. The projector will automatically power off when the countdown has
finished (in minutes).
Note:
The Sleep Timer is reset every time when the projector is powered off.
‡
Always On: Check to set the sleep timer always on.
Power Mode (Standby)
Set the power mode setting.
‡
Active: Choose "Active" to return to normal standby.
‡
Eco: Choose "Eco." to save power dissipation further < 0.5W.
USB Power (Standby)
Enable or disable the USB power function when the projector is in standby mode.
41
English
Advertisement
Table of Contents
