Table of Contents
Advertisement
USING THE PROJECTOR
Setup menu
Projection
Select the preferred projection between front, rear, ceiling-top, and rear-top.
Power Settings
Configure power settings.
‡
Direct Power On: Choose "On" to activate Direct Power mode. The projector will automatically power
on when AC power is supplied, without pressing the "Power" key on the projector keypad or on the
remote control.
‡
Signal Power Off: Choose "On" to activate Signal Power mode. The projector will automatically power
on when a signal is detected, without pressing the "Power" key on the projector Keypad or on the
remote control.
Note:
‡
This function is applicable with VGA and HDMI sources.
‡
Signal Power On can only be used for one HDMI port at a time. Signal Power On will not work
if there is more than one source device connected to the projector. If more than one source
device will be used with Signal Power On, please use a HDMI Switch.
‡
Auto Power Off (min): Sets the countdown timer interval. The countdown timer will start, when there
is no signal being sent to the projector. The projector will automatically power off when the countdown
has finished (in minutes).
‡
Sleep Timer (min.): Configure the sleep timer.
‡
Sleep Timer (min.): Sets the countdown timer interval. The countdown timer will start, with or
without a signal being sent to the projector. The projector will automatically power off when the
countdown has finished (in minutes).
Note:
The Sleep Timer is reset every time when the projector is powered off.
‡
Always On: Check to set the sleep timer always on.
‡
Power Mode (Standby): Set the power mode setting.
‡
Active (SmartHome): Choose "Active (SmartHome)" to return to normal standby.
‡
Eco: Choose "Eco." to save power dissipation further < 0.5W.
‡
USB Power (Standby): Enable or disable the USB power function when the projector is in standby
mode.
Security
Configure security settings.
‡
Security: Enable this function to prompt for a password before using the projector.
‡
Off: Choose "Off" to be able to switch on the projector without password verification.
‡
On: Choose "On" to use security verification when the turning on the projector.
Note:
The default password is 1234.
‡
Security Timer: Can be select the time (Month/Day/Hour) function to set the number of hours the
projector can be used. Once this time has elapsed you will be requested to enter your password again.
Change Password: Use to set or modify the password that is prompted when turning the projector on.
‡
39
English
Advertisement
Table of Contents
