Using The Projector; Powering On / Off The Projector - Optoma DLP ZH507+ User Manual

USING THE PROJECTOR

Powering on / off the projector

Powering on
1. Securely connect the power lead and signal/source cable. When connected, the Power LED will turn
red.
2. Turn on the projector by pressing the
3. A start up screen will display in approximately 10 seconds and the Power LED will begin flashing blue.
Note:
The first time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1. Turn off the projector by pressing the
2. The following message will be displayed:
3. Press the
you press the
4. The cooling fans will continue to operate for about 1 second for the cooling cycle and the Power LED
will flash blue. When the Power LED turns solid red, this indicates the projector has entered standby
mode. If you wish to turn the projector back on, you must wait until the cooling cycle has finished and
the projector has entered standby mode. When the projector is in standby mode, simply press the
button again to turn on the projector.
5. Disconnect the power lead from the electrical outlet and the projector.
Note:
It is not recommended that the projector be turned on immediately, right after a power off procedure.
English
22
button again to confirm, otherwise the message will disappear after 15 seconds. When
button for the second time, the projector will shut down.
or
Enter
button on the projector keypad or remote control.
button on the projector keypad or remote control.
Power Off
Press power key again.