Connecting A Modem To The Instant Internet Unit; Connecting To An Instant Internet Unit - Nortel BayStack Instant Internet 100-S User Manual

Connecting a modem to the Instant Internet unit

Before you connect the modem to the Instant Internet unit, you must turn off the
unit.
To connect a dial-up modem to the Instant Internet unit:
1
Turn off the Instant Internet unit.
2
Plug one end of the DB9 serial cable into the AUX port on the rear of the
Instant Internet unit.
3
Plug the other end of the cable into the modem.
4
Plug one end of the telephone cord into the modem and the other end into the
wall phone jack.
5
Turn on the modem.
6 Turn on the Instant Internet unit.
If you are configuring the unit, wait for LED 2 to glow amber.

Connecting to an Instant Internet unit

You can use any terminal emulation software application to dial in to the Instant
Internet unit.
To connect to the Instant Internet unit:
After you establish a connection, you can begin using remote access commands to
configure the unit. For details, refer to Reference for the BayStack Instant Internet
Remote Access Commands Version 7.11.
Note: Before you continue with this procedure, be sure that you have
properly configured the modem connection settings. For details, refer
"Configuring modem connection settings" on page
Dial the telephone number of the modem attached to the unit.
Chapter 7 Out-of-band management support
Setting Up the BayStack Instant Internet 100-S Unit
69
66.