Table of Contents
Advertisement
Quick Links
Pneumatic Arm Single Monitor Desk Mount
Instruction Manual
SKU: STAND-V001Q
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
https://vivo-us.com/products/stand-v001q
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST
help@vivo-us.com
www.vivo-us.com
Chat live with an agent!
309-278-5303
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vivo STAND-V001Q
Summary of Contents for Vivo STAND-V001Q
- Page 1 Pneumatic Arm Single Monitor Desk Mount Instruction Manual SKU: STAND-V001Q Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-v001q GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com...
- Page 2 WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
- Page 3 TOOLS NEEDED DO NOT EXCEED WEIGHT CAPACITY. 2-20lbs (1-9kg) Failure to do so may result in serious injury. Phillips Screwdriver ASSEMBLY STEPS STEP 1 OPTION A: Clamp Installation Install Clamp Base Support (C) onto base of Monitor Stand (A) with M6x10mm Screws (S-B) using 4mm Allen Wrench (T-A).
- Page 4 STEP 1 (Continued) OPTION B: Grommet Base Installation Slide M8x105mm (S-A) through the top of the Base Support (F) and install on base of Monitor Stand (A) with M6x10mm Screws (S-B) using 4mm Allen Wrench (T-A). Apply Pads (I) to bottom of Base Support (F).
- Page 5 STEP 2 Position VESA Plate (B) on back of monitor and secure with Screws (M-A or M-B) with M5 Washers (M-C). M- A M- B M- C STEP 3 Pull back latch on monitor arm, and slide monitor into place. STEP 4 If needed, adjust the bolt on the side of the hinge behind the VESA plate to tighten or loosen the tilt...
- Page 6 STEP 5 Remove cable covers as shown from upper and lower arms.
- Page 7 STEP 6 Replace covers making sure the cables have enough slack to allow free movement of the arm. STEP 7 Store tools in Cable Clip (E) if clamp option is used. 180° +90° 180° -90° 360° 270°...
- Page 8 : 1HR 8M (within office hrs) - 23% within < 15m - 38% within < 30m - 61% within < 1hr - 83% within < 2hr - 92% within < 3hr FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com...
Need help?
Do you have a question about the STAND-V001Q and is the answer not in the manual?
Questions and answers