Page 1
Single Monitor Desk Mount Instruction Manual SKU: STAND-V001,W Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-v001 GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.com...
Page 2
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury.
Page 3
ASSEMBLY STEPS STEP 1 Option A: Desk Clamp Install Option B: Grommet Install Loosen Clamp Bolt (B1) on Clamp (B). Install Using a Phillips screwdriver, remove the screw Clamp (B) to Pole (A) using M6x16mm Screws from Clamp (B) and separate Clamp Bolt (B1) (S-A) and 3mm Allen Wrench (T-A).
Page 4
STEP 2 Slide Pole Cable Clip (I) and Arm (C) over Pole (A). Secure Arm (C) at the desired height using 5mm Allen Wrench (T-B). Insert Pole Cap (G) into the top of Pole (A). STEP 3 Attach Arm Cable Clips (H) to Arm (C).
Page 5
STEP 4 OPTION A: Flat Back Monitor Attach the VESA plate (D) to the monitor with Thumbscrews (M-A). NOTE: Hand tighten screws to avoid over tightening. OPTION B: Curved Back Monitor Attach the VESA Plate (D) to the monitor with M4x30 Screws (M-B) and M6 Spacers (M-C). NOTE: Gently tighten using a screwdriver...
Page 6
STEP 5 Slide VESA Plate (D) with the monitor onto Arm (C). Secure the assembly in place using M6 Nut (S-B). STEP 6 Manage cables using Arm Cable Clips (H) and Pole Cable Clip (I).
Page 7
STEP 7 Adjust the tilt using 5mm Allen Wrench (T-B).
Page 8
: 1HR 8M (within office hrs) - 23% within < 15m - 38% within < 30m - 61% within < 1hr - 83% within < 2hr - 92% within < 3hr FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com...
Need help?
Do you have a question about the STAND-V001 and is the answer not in the manual?
Questions and answers