Making Walking And Pushing The Bicycle Easy (Walk Assist) - Shimano STEPS Series User Manual

Basic operation

Making walking and pushing the bicycle easy (walk assist)

1. On the main screen: Press <A>. (Switches the traveling data display to [DST])
2. Press and hold <A>. (Continue to hold down until the number displayed for [DST] flashes.)
3. When the number displayed for [DST] is flashing: Press <A>.
The traveling data is reset.
If nothing is done for five seconds after the number for [DST] begins flashing, it will stop flashing
and the screen will return to the main screen. The display will automatically return to the main
screen when the start of traveling is detected.
Making walking and pushing the bicycle easy (walk
assist)
Depending on the region of use, you may not be able to use it due to the laws of the region. In this case, the
operations described here are disabled.
1. Stop and switch to walk assist mode.
Press and hold Y until it reaches the following state.
Y
If nothing is done for one minute after switching to walk assist mode, it will switch back to the
assist mode that was selected before switching.
Walk assist icon
17