Introduction; Features - SINGULARITY COMPUTERS PHANTOM Assembly Manual

Introduction

Phantom turns the Singularity Computers PowerBoard into the case itself. The goal was to create
the most minimalistic case using PCB only. Phantom does not aim to be the smallest Mini-ITX
case, but to achieve maximum component density with unrestricted airflow. Phantom disappears
amongst the components mounted to it, it is completely about component selection and will
show off the skill of the builder. It fits ITX and DTX motherboards, 3+ slot graphics cards, ATX
power supplies and 3x 2.5" drives or 2x 2.5" and a 3.5" drive. Water-cooling is possible with the
included universal radiator mount which fits 120mm, 140mm, 240mm, 280mm, 360mm, 420mm,
480mm and 560mm radiators. There is no limitation on radiator thickness and push pull fans also
fit. All components are mounted directly onto the PowerBoard which acts as a rack as well as a
power distribution plate. It has the MB 24pin and EPS power integrated along with Power and
Reset buttons. There are integrated direct connect SATA power connections to avoid the use of
SATA power cables. The built-in handle makes lifting the whole system easy to transport by hand.
There is no rear access needed to the case for cable management, all cables can be connected
from the front. Black sleeved cables are included with the case and custom colored sleeved
linking cables can be purchased separately.

Features

PowerBoard Integration
•
The Phantom PowerBoard is a PCB integrating 24pin, EPS, SATA, Power, and Reset Buttons.
Essentially, the PowerBoard is a distribution plate for cables while integrating other features
and functions as well. It is a new method for cables allowing standardization of cable lengths
and making traditional cable management no longer necessary. Phantom comes included with
a standard set of black sleeved linking cables including 24pin x1 and 8pin EPS x1 meaning that
these cables don't have to be purchased separately.
Reduced build time due to integration
•
Cables do not need to be purchased separately and no cable management is needed for the
core component cables.
High End Components
•
It is designed to fit the largest high-end GPUs. It can fit the largest PSUs although it is
recommended to pick a short and light PSU to make transporting the system easier, same
applies to the GPU. For the water-cooling system it can fit a single 240mm radiator with
unlimited thickness and pull/pull fans.
Radiator Adjustment
•
The additional 240 Radiator Mount is adjustable to help with port alignment and to turn the
radiator into a support leg.
Storage
•
Phantom PowerBoard has 3x SATA Drive positions. 2X 2.5" are at the mid-section of the back
side of the PCB and 1x 2.5"/3.5" is at the top-section above them.
Revision 1.0
Phantom ITX/DTX Case Assembly Manual
Page | 2