Set Up Fsd And E2 Communication; Step 1: Add Fsd To E2; Step 2: Set U Pip Address For The Fsd - Emerson Facility E2 Installation And Operation Manual

3 Set Up FSD and E2 Com-
munication
Because the FSD device retrieves all software infor-
mation from the E2 controller, communication must
be established between the FSD and the E2 at start-up.
To start, add the FSD application to the E2.

3.1. STEP 1: Add FSD to E2

1. Log into the E2 controller and press the
Menu button.

2. Press (System Configuration)

3. Press (Network Setup)

4. Press (Connected I/O Boards & Con-
trollers)
5. Cursor down to ECT Devices and add
the desired number of Status Display de-
vices.
Figure 3-1 - Add FSD Under ECT Devices
3.2. STEP 2: Set Up IP Address
for the FSD
DHCP is enabled by default. If you have a DHCP
server, the FSD will retrieve an IP Address automati-
cally. If you wish to set up a static IP Address, follow
STEP 1: Add FSD to E2
these steps:
1. Touch the tool icon
passcode on the security screen (default
code is 400) as shown in Figure 5-10.
2. Select the General tab and the Exit Ap-
plication button.
3. A loader screen will appear. Touch Exit
Loader at the top right of the screen.
4. The desktop screen will appear. Select
Start>Settings>Network and Dial-up
Connections.
5. Double-click the icon labeled
SMSC91181.
6. From the IP Address tab, (Figure 3-2)
choose Specify an IP address. (If using
a Hostname for E2 instead of an IP Ad-
dress, contact your IT administrator and
continue from Step 9.)
Figure 3-2 - IP Address Tab
7. Toggle the virtual keyboard by touching
the keyboard/pen icon
right to toggle the virtual keyboard:
8. Enter the IP Address, Subnet Mask, and
Default Gateway as specified by your IT
administrator.
9. Click OK to save; close the next window.
10. Once at the desktop screen, click the re-
boot icon
Click OK on the Do you want to reboot?
window:
Set Up FSD and E2 Communication • 5
and enter the
on the lower
at the bottom of the screen.