Dr Detector Battery - AGFA DX-D 40C User Manual

DX-D 40C, DX-D 40G | Introduction to the DR Detector | 51

DR Detector Battery

Safety Directions
Warning:
Do not use any charger other than that specifically provided
for use with the equipment.
Use only a power adapter complying with IEC 60601-1 or
IEC 60950-1.
Make sure to turn off the detector before detaching a battery
pack. Press and hold the power button for about 3 seconds.
All status LED lamps are off and then the detector is turned
off.
When the detector is not to be used for some time, remove
the battery pack. Otherwise, over discharge may occur
resulting in the shortened battery life.
Securely plug the power cord of the charger into the AC
outlet. If contact failure occurs, or if dust/metal objects
come into contact with the exposed metal prongs of the
plug, fire or electric shock may result.
Stop charging the battery when status LED of the charger
turns to green as exceeding the specified charging time.
Otherwise, the battery pack is overcharged and it causes
smoke. If the battery pack is overheating, it can be exploded
and a fire may occur.
Always check the remaining amount of the battery pack
during use of the detector. If performance of the battery
pack has some problems, consult your local Agfa
representative.
Do not use the battery pack as a power source for
equipment other than DX-D 40C or DX-D 40G detectors. Be
sure to use only the dedicated battery pack for the DX-D 40C
or DX-D 40G detector.
The battery charger is designed for the dedicated battery
pack. Do not use the battery charger other than the
dedicated one. Otherwise, a battery explosion or a battery
leak may occur, resulting in fire or electrical shock.
Do not operate the battery charger using any type of power
supply other than the one indicated on the rating label.
Do not handle the product with wet hands.
Do not attempt to disassemble, alter, or apply heat to the
product.
0290A EN 20140626 1622