Resetting the Transmitter
Restores the transmitter to the following factory settings:
•
Controls = unlocked
Press and hold the transmitter link button while turning on the transmitter until power LED turns off.
When the link button is released, the transmitter will automatically initiate linking to find an available receiver. Press the link but
ton on an available receiver to relink.
Troubleshooting
Issue
No sound or faint sound
Audio artifacts or dropouts
Indicator Status
Solution
Verify all sound system connections or ad
just gain as needed.
Receiver RF LED on
Verify that the receiver is connected to mix
er/amplifier.
Turn on transmitter.
Make sure the batteries are installed correct
Receiver RF LED off
ly.
Link transmitter and receiver.
Charge or change transmitter battery.
Make sure AC adapter is securely plugged
Receiver display off
into electrical outlet.
Make sure receiver is powered on.
Transmitter indicator
Charge or change transmitter battery.
LED flashing red
Transmitter plugged
Disconnect transmitter from charger.
into charger.
Change receiver and transmitter to a differ
ent group and/or channel.
Identify nearby sources of interference (cell
phones, WiFi access points, signal proces
sor, etc.) and shutdown or remove source.
RF LED flickering or off
Charge or change transmitter battery.
Ensure that receiver and transmitter are po
sitioned within system parameters.
System must be set up within recommended
range and receiver kept away from metallic
surfaces.
Shure Incorporated
19/38