To change the band mode:
1.
Press and hold the channel button while powering on the receiver. Continue to hold the channel button for approximate
ly 5 seconds until the band selection menu opens.
2.
Press the up/down gain button to select a band mode. The screen will flash momentarily and scan for the best channel
to use.
Note: Linked receivers and transmitters must be able to operate in the same band. Transmitters that don't support the selected band mode will unlink from the
receiver.
Tuner Menu
Enter tuner mode by pressing the footswitch.
In tuner mode, the controls will only affect tuner functions. RF and audio settings are not affected.
Note:
•
Wired use: Wired input does not load the guitar signal, eliminating the need for bypass switches. The unit passes wired
signal if power is lost to the pedal.
•
Wireless use: Bypass does not apply because the pedal needs to be powered on to receive wireless signal.
Tuner Options
•
Indicator: Needle or Strobe
•
Output: Live, Mute, or Both
•
Display Brightness
•
Detune
•
Sharps and Flats
•
Reference Pitch
Selecting and Editing Tuner Menu Settings
Use the following buttons to select and edit the tuner menu settings:
•
Use the mode button to access the menu and scroll between menu settings.
•
Use the ▲ ▼ buttons to change a menu parameter.
•
Use the footswitch to enter and save parameter changes.
Indicator: Needle or Strobe
The tuner indicator can be set to display a needle style or strobe style.
Needle
A single LED will illuminate on the tuning bar to indicate sharp or flat. The green center LED will illuminate when the note is in
tune.
Shure Incorporated
13/38