Issue
Second frequency manager
does not send RF signal to re-
ceivers
RF interference while connect-
ed to frequency manager
SB902A battery will not charge
in GLXD1 bodypack transmitter
Resetting Components
Use the reset function if it is necessary to restore the transmitter or receiver to their factory settings.
Resetting the Receiver
Restores the receiver to the following factory settings:
•
Gain level = default
•
Controls = unlocked
Press and hold the link button while turning on the receiver power until the LCD displays RE.
Note: When reset is complete, the receiver will automatically initiate linking to search for a transmitter. Press and hold the transmitter link button within five
seconds of powering-on to complete the link.
Resetting the Transmitter
Restores the transmitter to the following factory settings:
•
Controls = unlocked
Press and hold the transmitter link button while turning on the transmitter until power LED goes off.
When the link button is released, the transmitter will automatically initiate linking to find an available receiver. Press the link but
ton on an available receiver to relink.
Specifications
Tuning Bandwidth
2400–2483.5 MHz
Working Range
Indoor
Indicator Sta-
Solution
tus
Verify that antenna A and antenna B ports on second frequency
Data sync LED
manager are connected to cascade A and cascade B ports on first
off
frequency manager.
Move system away from other 2.4 GHz sources such as WiFi ac
Receiver screen
cess points or computers. If using directional antennas, place inter
flashes
ference sources behind antennas in the null to minimize interfer
ence. Place receivers or directional antennas closer to transmitters.
Rapid flashing
Charge battery once in GLXD4 receiver or SBC902 charger. Subse
green LED on
quent recharging can occur in GLXD1 bodypack.
GLXD1
Up to 30 m ( 100 ft) typical, Up to 60 m
( 200 ft) maximum
Shure Incorporated
26/33