Locking And Unlocking The Controls; Identifying Linked Transmitters And Receivers With Remote Id; Receiver Band Modes - Shure GLXD6+ Manual

Locking and Unlocking the Controls

The controls of the receiver and transmitter can be locked to prevent unauthorized setting changes or power­off. The lock sta­
tus is not changed by power cycles.
Locking the Receiver Controls
Simultaneously press and hold the group and channel buttons until LK appears on the screen. Repeat to unlock.
• LK is displayed if a locked control is pressed
• UN is displayed momentarily to confirm the unlock command
Locking the Transmitter Controls
To lock directly from the transmitter:
Start with the transmitter off, then press and hold the link button while turning on the transmitter. Release the link button when
the transmitter powers on to prevent an accidental factory reset. The lock icon appears on the receiver screen when locked.
Repeat sequence to unlock.
To lock from the receiver front panel:
Simultaneously press and hold the group and link buttons for approximately 2 seconds until the flashing lock icon appears on
the receiver screen. Repeat sequence to unlock.
Note: The transmitter status LED will flash if a locked switch is set to the off position.

Identifying Linked Transmitters and Receivers with Remote ID

Use the remote ID feature to identify linked transmitter and receiver pairs in multiple receiver systems.
To activate remote ID:
1. Momentarily press the link button on the transmitter or receiver.
2. The screen of the linked receiver will blink and display ID, while the status LED on the linked transmitter will flash red/
green.
3. To exit remote ID mode, momentarily press the link button or allow the function to timeout.

Receiver Band Modes

There are 3 band modes available for GLXD+ receivers. The band mode options are:
• 2.4 GHz-only mode
• 5.8 GHz-only mode
• Best band mode – 2.4 and 5.8 GHz (default)
Shure Incorporated
12/38