Shure GLXD24RE Manual

Shure GLXD24RE Manual

Half-rack wireless receiver

Advertisement

Quick Links

IMPORTANT SAFETY INSTRUCTIONS
1. READ these instructions.
2. KEEP these instructions.
3. HEED all warnings.
4. FOLLOW all instructions.
5. DO NOT use this apparatus near water.
6. CLEAN ONLY with dry cloth.
7. DO NOT block any ventilation openings. Allow sufficient distances for
adequate ventilation and install in accordance with the manufacturer's
instructions.
8. DO NOT install near any heat sources such as open flames, radiators,
heat registers, stoves, or other apparatus (including amplifiers) that pro-
duce heat. Do not place any open flame sources on the product.
9. DO NOT defeat the safety purpose of the polarized or grounding type
plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The
wider blade or the third prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for replacement
of the obsolete outlet.
10. PROTECT the power cord from being walked on or pinched, particularly
at plugs, convenience receptacles, and the point where they exit from
the apparatus.
11. ONLY USE attachments/accessories specified by the manufacturer.
12. USE only with a cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. UNPLUG this apparatus during lightning storms or when unused for long
periods of time.
14. REFER all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power
supply cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
WARNING: Battery packs shall not be exposed to excessive heat such as
sunshine, fire, or the like.
WARNING: Danger of explosion if incorrect battery replaced. Operate only
with AA batteries.
WARNING: This product contains a chemical known to the State of California
to cause cancer and birth defects or other reproductive harm.
WARNING
Battery packs may explode or release toxic materials. Risk of fire or
burns. Do not open, crush, modify, disassemble, heat above 140°F
(60°C), or incinerate
Follow instructions from manufacturer
Never put batteries in mouth. If swallowed, contact your physician or local
poison control center
Do not short circuit; may cause burns or catch fire
©2017 Shure Incorporated
15. DO NOT expose the apparatus to dripping and splashing. DO NOT put
objects filled with liquids, such as vases, on the apparatus.
16. The MAINS plug or an appliance coupler shall remain readily operable.
17. The airborne noise of the Apparatus does not exceed 70dB (A).
18. Apparatus with CLASS I construction shall be connected to a MAINS
socket outlet with a protective earthing connection.
19. To reduce the risk of fire or electric shock, do not expose this apparatus
to rain or moisture.
20. Do not attempt to modify this product. Doing so could result in personal
injury and/or product failure.
21. Operate this product within its specified operating temperature range.
Explanation of Symbols
Caution: risk of electric shock
Caution: risk of danger (See note.)
Direct current
Alternating current
On (Supply)
Equipment protected throughout by DOUBLE INSULATION or
REINFORCED INSULATION
Stand-by
Equipment should not be disposed of in the normal waste stream
WARNING: Voltages in this equipment are hazardous to life. No user-ser-
viceable parts inside. Refer all servicing to qualified service personnel. The
safety certifications do not apply when the operating voltage is changed from
the factory setting.
Do not charge or use battery packs with other than specified Shure
products
Dispose of battery packs properly. Check with local vendor for proper
disposal of used battery packs
Note:
This equipment is intended to be used in professional audio applications.
EMC conformance is based on the use of supplied and recommended
cable types. The use of other cable types may degrade EMC perfor-
mance.
Use this battery charger only with the Shure charging modules and battery
packs for which it is designed. Use with other than the specified modules
and battery packs may increase the risk of fire or explosion.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate this equipment.
GLXD4R
Half-Rack Wireless Receiver
1/20

Advertisement

Table of Contents
loading

Summary of Contents for Shure GLXD24RE

  • Page 1 WARNING: Battery packs shall not be exposed to excessive heat such as • Do not charge or use battery packs with other than specified Shure sunshine, fire, or the like. products •...
  • Page 2: System Overview

    GLXD4R Half-Rack Wireless Receiver Shure Incorporated Note: Use only with the included power supply or a Shure-approved equiva- lent. System Overview GLX-D Advanced Digital Wireless Systems combine Automatic Frequency • Operates in globally unlicensed 2.4 GHz spectrum Management technology with a rack mountable metal receiver, rechargeable •...
  • Page 3 GLXD4R Half-Rack Wireless Receiver Shure Incorporated Step ① Connect power supply to the receiver and plug cord into an AC power source. Connect the audio output to an amplifier or mixer. Step ② Install charged transmitter batteries. Step ③ Turn on the transmitter and receiver. The blue rf LED will flash while the transmitter and receiver form a link. The rf LED turns solid blue when the link has suc- cessfully formed.
  • Page 4: Receiver Controls And Connectors

    GLXD4R Half-Rack Wireless Receiver Shure Incorporated Note: The transmitter and receiver will remain linked for future usage. At power-up, the blue rf LED and transmitter LED will illuminate, skipping the linking step. Step ④ Check the audio and adjust the gain if necessary.
  • Page 5: Rear Panel

    GLXD4R Half-Rack Wireless Receiver Shure Incorporated Rear Panel ① RF Status LED • ON = Linked transmitter is on. • Flashing = Searching for transmitter. • OFF = Linked transmitter off or transmitter unlinked. ② Group Button Press and hold for two seconds to enable manual group edit.
  • Page 6 GLXD4R Half-Rack Wireless Receiver Shure Incorporated ⑫ Power Supply Jack Connect the supplied 15 V DC external power supply. ⑬ Firmware Update Connect to computer to download firmware updates. ⑭ Mic/Line Switch Sets XLR output level to microphone or line level.
  • Page 7 Press and hold within 5 seconds of power-on to manually link with receiver • Press momentarily to activate Remote ID function ⑦ Battery Compartment Holds 1 Shure rechargeable battery. ⑧ Microphone Cartridge GLXD-2 transmitter models are available with the following cartridge types: SM58, Beta 58, SM86, Beta 87A.
  • Page 8: Batteries And Charging

    Half-Rack Wireless Receiver Shure Incorporated Batteries and Charging GLX-D transmitters are powered by Shure SB902 lithium-ion rechargeable Charging from an AC Power Source batteries. Advanced battery chemistry maximizes runtimes with zero memory effects, eliminating the need to discharge batteries prior to charging.
  • Page 9: Charging Times And Transmitter Runtimes

    Note: If receiver is powered off and remains plugged in, battery will continue charging. Important Tips for Care and Storage of Shure Rechargeable Batteries Proper care and storage of Shure batteries results in reliable performance • Ideally, batteries should be charged to approximately 40% of capacity and ensures a long lifetime.
  • Page 10: Coexisting With Wi-Fi

    You can also mount antennas remotely using Shure directional antennas to reduce transmitter-to-antenna distance. • Antenna mounting accessories and directional antennas (available sep-...
  • Page 11: Additional Tips

    GLXD4R Half-Rack Wireless Receiver Shure Incorporated Additional Tips • Do not place competitive 2.4 GHz receivers near GLXD4R receivers. • Connect more than two GLXD4R receivers to a GLX-D Frequency Manager to improve RF reliability. • Scan for the best available channel by pressing the channel button.
  • Page 12: Manually Linking A Transmitter To A Receiver

    GLXD4R Half-Rack Wireless Receiver Shure Incorporated Channel Count (Number of Number of Backup Group Notes Receivers) Frequencies Per Channel Only use Group 3 in controlled Wi-Fi environments because there are no backup Up to 8* frequencies to avoid interference. Best single-channel group if you experience interference.
  • Page 13 Firmware is embedded software in each component that controls functionality. Periodically, new versions of firmware are developed to incorporate additional features and enhancements. To take advantage of design improvements, new versions of the firmware can be downloaded and installed using the Shure Update Utility tool.
  • Page 14: Rack Mounting Instructions

    GLXD4R Half-Rack Wireless Receiver Shure Incorporated Rack-Mounting Instructions Use the supplied mounting hardware to install the receiver in a standard 19 inch audio equipment rack. 14/20 2017/11/28...
  • Page 15 GLXD4R Half-Rack Wireless Receiver Shure Incorporated 2017/11/28 15/20...
  • Page 16: Troubleshooting

    Reduce transmitter gain (see Gain Adjustment). on receiver LCD Transmitter and receiver LEDs flash to Update both components to firmware version 2.0 or greater. Download the Shure Update Transmitter and receiver link unsuccessful indicate that linking Utility application and follow the instructions.
  • Page 17: Resetting Components

    Press the link button on an available re- ceiver to relink. Specifications Tuning Bandwidth Transmit Mode 2400–2483.5 MHz Shure GLX-D proprietary digital Working Range Audio Frequency Response 20 Hz – 20 kHz Up to 30 m (100 ft) typical, Indoor...
  • Page 18 GLXD4R Half-Rack Wireless Receiver Shure Incorporated RF Sensitivity Maximum Input Level 1 kHz at 1% THD -88 dBm, typical +8.4 dBV (7.5 Vp-p) Total Harmonic Distortion Antenna Type 0.2%, typical Internal Monopole RF Output Power Pin Assignments 10 mW E.I.R.P. max...
  • Page 19 GLXD4R Half-Rack Wireless Receiver Shure Incorporated Weight Audio Output 267 g (9.4 oz.) without Configuration SM58 batteries XLR Output Balanced 221 g (7.8 oz.) without BETA 58 batteries 6.35 mm (1/4") output Impedance balanced 275 g (9.1 oz.) without SM86...
  • Page 20: Information To The User

    • Consult the dealer or an experienced radio/TV technician for help. 運用に際しての注意 この機器の使用周波数帯では、電子レンジ等の産業・科学・医療用機器の ほか工場の製造ライン等で使用されている移動体識別用の構内無線局(免 許を要する無線局)及び特定小電力無線局(免許を要しない無線局)並び にアマチュア無線局(免許を要する無線局)が運用されています。 1. この機器を使用する前に、近くで移動体識別用の構内無線局及び特定 小電力無線局並びにアマ チュア無線局が運用されていないことを確認 して下さい。 Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: info@shure.com 20/20...

This manual is also suitable for:

Glxd4rGlxd14r

Table of Contents