Table of Contents
Advertisement
U3020AD01
Description
Description
The Keysight U3020AD01 Dynamic Accuracy Test Set is designed for use with the PNA-X
Network Analyzers and based on the L4490A RF Switch Platform.
The U3020AD01 is used to characterize the PNA-X power linearity (dynamic accuracy)
designed for maximum measurement accuracy over a 110 dB dynamic range. The signal is
controlled via internal attenuators.
The U3020AD01 can only be controlled using an external GPIB controller or LAN.
When using Keysight IO Libraries "Connection Expert Utility," the interface identifies the Test
Set as "U3020A" without D01. D01 will be listed on the rear panel serial tag.
Verifying the Shipment
To verify the contents shipped with your product, refer to the "Box Content List" included with
the shipment.
Inspect the shipping container. If the container or packing material is damaged, it should be
kept until the contents of the shipment have been checked mechanically and electrically. If
there is physical damage refer to
"Contacting Keysight" on page
34. Keep the damaged
shipping materials (if any) for inspection by the carrier and an Keysight Technologies
representative.
Network Analyzer Requirements
• The N5247A PNA-X Network Analyzer (10 MHz to 67 GHz)
More PNA-X information is available on the following websites:
• Documentation -
http://www.keysight.com/find/pna
• Network Analyzer Firmware -
http://na.support.keysight.com/pna/firmware
User's and Service Guide U3020-90004
3
Advertisement
Table of Contents
