E Command Echo; Fax Commands; H Hang Up Call; I Request Identification Information - Nokia 6090 Command Manual

E Command Echo

Fax Commands

H Hang Up Call

I Request Identification Information

L Monitor Speaker Loudness

M Monitor Speaker Mode

Nokia 6090 AT Command Set
This command determines whether characters that are received from the DTE are
echoed or not in the command mode. (V.25ter)
Syntax:
ATE[0]
ATE1
The following fax (+F) command sets are available for use by the Nokia 6090 that
supports GSM 03.45 facsimile group 3 transparent:
Class 1, TIA-578-A
Class 2, TIA SP-2388
Class 2.0, TIA-592 and ITU-T T.32
Error correction mode (ECM) in Class 2 and 2.0 is supported.
This command normally hangs up the call. If the alternating call data mode is
currently active, ATH does not hang up the call but call mode is switched from data to
voice. If you want to disconnect the alternating call, you must use the AT+CHUP
command instead. (V.25ter)
Syntax:
ATH[<n>]
This command displays information on the TA. (V.25ter)
Syntax:
ATI[0]
ATI1
ATI2
ATI3
ATI4...ATI13
This setting is ignored. It is included for compatibility reasons. (V.)
Syntax:
ATL[<n>]
This setting is ignored. It is included for compatibility reasons. (V.25ter)
Syntax:
ATM[<n>]
Disable echoing
Enable echoing. Default option.
Hang up call. <n>=0
Displays the TA manufacturer
identification (same as for +GMI).
Response is Nokia Mobile Phones
Displays the product serial number (same
as for +GSN).
Displays the product version (same as for
+GMR).
Displays the product name (same as for
+GMM).
Response is Nokia 6090 - GSM900 Fixed
Mobile Phone
Dummy values that are just accepted.
L[0]...L3
M[0]...M2
60