Nokia 6090 Command Manual page 61

Nokia 6090 AT Command Set
ATD><n> [;]
ATD[;]
ATD> <string>
ATDL
<dial-string> Characters
<dial-string> characters
V.25ter dialling digits
V.25ter modifiers
V.25ter semicolon
GSM 07.07 modifiers
de facto
See also 07.07 and V.25ter. For voice call example refer 07.07 annex G. Note that I
is the only case-sensitive dial-string character.
Result Codes
All result codes are not in V.25ter. Before one of the above codes may be returned
some of the following: +CSSI, +COLP, +CR (or CARRIER), +ER, +DR, or +ILRR (in
that order).
Possible verbose Numeric
result codes (V1) (V0)
BLACKLISTED 14
BUSY 7
CONNECT 1
CONNECT 1200 5
CONNECT 2400 10
CONNECT 4800 11
CONNECT 9600 12
DELAYED 13
ERROR 4
NO ANSWER 8
NO CARRIER 3
OK 0
in case of SIM ADN memory (SM) also
D>SIM shall be accepted (due to
inconsistency in 07.07).
Dials a stored number from a data
software memory location <n>.
Dials a stored number from a data
software memory location 0.
Dial a number assigned to name <string>.
Redials the last number that has been
dialled during the current session.
Values Description
0123456789+ accepted as valid digits
*#ABCD cause ERROR
, in case of voice call: originate call to
the number preceding comma, wait for
remote answer, pause for length
specified with S8 register, and send
numbers after comma as DTMF digits;
further commas cause pause for
length specified with S8 register (all
commas are ignored in case of data
call)
T P ! W @ accepted but ignored
; voice call originating (must be last
character in command line)
> direct dialling from phonebook (must
be first char after D) (see next table)
i allow calling line id presentation for
this call
I restrict calling line id presentation for
this call
G control CUG information for this call;
use +CCUG values
L redial to the number last dialled
Description
call to the number is forbidden until manual reset
called party is busy
data/fax call established; rate 300 bps (or X
forbids rate display)
data/fax call established; rate 1200 bps
data/fax call established; rate 2400 bps
data/fax call established; rate 4800 bps
data/fax call established; rate 9600 bps
call to the number is temporarily (5 sec - 3 min)
forbidden
command cannot be actioned
called party does not answer
call could not be established
command aborted or voice call started with
semicolon character
59