E Command Echo; H Hang Up Call; I Request Identification Information - Nokia 8850 Command List

E Command Echo

H Hang Up Call

I Request Identification Information

AT Command Set for Nokia 8850
Result Codes
All result codes are not in V.25ter. Before one of the above codes may be returned
some of the following: +CSSI, +COLP, +CR (or CARRIER), +ER, +DR, or +ILRR (in
that order). Available connection rates depend on the product.
possible verbose
result codes (V1)
BLACKLISTED
BUSY
CONNECT
CONNECT 1200
CONNECT 2400
CONNECT 4800
CONNECT 9600
CONNECT 14400
CONNECT 19200
CONNECT 28800
DELAYED
ERROR
NO ANSWER
NO CARRIER
OK
This command determines whether characters that are received from the DTE are
echoed or not in the command mode. (V.25ter section 6.2.4.)
Syntax:
ATE[0]
ATE1
This command normally hangs up the call. If the alternating call data mode is
currently active, ATH does not hang up the call but call mode is switched from data to
voice. If you want to disconnect the alternating call, you must use the AT+CHUP
command instead. (V.25ter section 6.3.6.)
Syntax:
ATH[<n>]
This command displays information on the TA. (V.25ter section 6.1.3.)
Syntax:
ATI[0]
ATI1
ATI2
ATI3
ATI4...ATI13
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
numeric
(V0) description
14 call to the number is forbidden until manual reset
7 called party is busy
1 data/fax call established; rate 300 bps (or X
forbids rate display)
5 data/fax call established; rate 1200 bps
10 data/fax call established; rate 2400 bps
11 data/fax call established; rate 4800 bps
12 data/fax call established; rate 9600 bps
17 HSCSD (or 14.4 tch) data/fax call established;
rate 14400 bps
18 HSCSD data/fax call established; rate 19200 bps
19 HSCSD data/fax call established; rate 28800 bps
13 call to the number is temporarily (5 sec - 3 min)
forbidden
4 command cannot be actioned
8 called party does not answer
3 call could not be established
0 command aborted or voice call started with
semicolon character
Disable echoing
Enable echoing. This is the default option.
Hang up call. <n>=0
Displays the TA manufacturer
identification (same as for +GMI).
Displays the product serial number (same
as for +GSN).
Displays the product version (same as for
+GMR).
Displays the product name (same as for
+GMM).
Dummy values that are just accepted.
48