+CHUP Hang Up Call
+CIMI Request international mobile subscriber identity
+CIND Indicator Control
Nokia 6090 AT Command Set
This command hangs up the call, also when an alternating mode call is active. This is
an assured procedure to terminate an alternating mode call. (GSM 07.07).
Syntax:
AT+CHUP
AT+CHUP=?
Execution command causes the 6090 to return <IMSI>, which is intended to permit
the TE to identify the individual SIM which is attached to 6090.
Important note: This feature is available in 5.300 SW or later.
Syntax:
AT+CIMI
AT+CIMI=?
Parameters:
<IMSI> : International Mobile Subscriber Identity
Example:
AT+CIMI
Request IMSI
Response:
262092100065749 (dependent on SIM IMSI number)
OK
Queries the current status of ME physical indicators. Indicator writing not supported
('set' command returns always ERROR, or +CME ERROR when allowed by +CMEE).
(GSM 07.07)
Syntax:
AT+CIND?
AT+CIND=?
Parameters:
<ind>: integer type value, which shall be in range of corresponding <descr>
<descr> values reserved and their <ind> ranges:
"message"
"call"
"smsfull"
Examples:
AT+CIND=?
Request all suported indicators
Response:
+CIND: ("message",(0,1)),("call",(0,1)),("smsfull",(0,1))
OK
Hang up call. Response is OK.
OK
<IMSI>
OK
Query current setting.
Response is +CIND: <ind>[,<ind>[,...]]
Show supported values.
Response is +CIND:(<descr>,(list of
supported)), see GSM 07.07
message received (0-1)
call in progress (0-1)
a short message memory storage in the
MT has become full (1), or memory
locations are available (0); i.e. the range is
(0-1)
20