Cr Service Reporting Control; Crc Cellular Result Codes - Nokia 6090 Command Manual

+CR Service Reporting Control

+CRC Cellular Result Codes

Nokia 6090 AT Command Set
AT+CPWD="P2","5678","12345678"
changes "PIN2 code" from the old 5678 value, to 12345678.
This command controls the presentation of the +CR intermediate result code. If
enabled, the result code is transmitted at the point during the connect negotiation
during which the speed and quality of service to be used have been determined,
before any error control or data compression reports are transmitted, and before any
final result code (e.g., CONNECT) is transmitted. (GSM 07.07)
Syntax:
AT+CR=<mode>
AT+CR?
AT+CR=?
Parameters for <mode>:
0
1
This command controls whether or not the extended format incoming call indication is
used. When enabled, an incoming call is indicated to the DTE with the result code
+CRING:<type> instead of the normal RING. See also section Result Codes from
page 77 onwards. (GSM 07.07)
Syntax:
AT+CRC=[<mode>]
AT+CRC?
AT+CRC=?
Values for <mode>:
0
1
Set service reporting control mode.
Default option is 0.
Query current setting.
Response is +CR:<mode>.
Show supported values.
Response is +CR:(list of supported
<mode>'s).
Disable reporting.
Enable reporting.
Set incoming call indication mode.
Default option is 0.
Query current setting
Response is +CRC:<mode>
Show supported modes.
Response is +CRC:(list of supported
<mode>'s).
Disable extended format call indication.
Enable extended format call indication.
42