Installing The Adapter; Installing The Adapter (Without Dr) - Sun Microsystems GigabitEthernet/S 2.0 Installation And User Manual

2
C H A P T E R

Installing the Adapter

This chapter describes how to install a Sun GigabitEthernet adapter in your system
and how to verify that it has been installed correctly. If you have a Sun Enterprise
6x00,5x00, 4x00, or 3x00 system that supports Dynamic Reconfiguration (DR), see
"Installing the Adapter (with DR)" on page 9.
Refer to the Sun Enterprise 6x00/5x00/4x00/3x00 Dynamic Reconfiguration User's
Guide for further information.
(without DR)
Note – Refer to your system installation or service manual for detailed instructions
for the following tasks.
1. Halt and power off your system.
2. Open the system unit.
1. Attach the adhesive copper strip of the wrist strap to the metal casing of the
power supply. Wrap the other end twice around your wrist, with the adhesive side
against your skin.
2. Holding the SBus adapter by the edges, unpack and place it on an antistatic
surface.
3. If you are replacing an old SBus adapter with the Sun GigabitEthernet/S adapter,
remove the old adapter now.
4. Install the Sun GigabitEthernet/S adapter in the selected SBus slot.
Installing the Adapter
5