To Set Auto-Negotiation to off on a SunSwitch
or Alteon ACE 110 Switch
Set the auto-negotiation parameter to off on the switch and the ge adapter. Refer
to the user's manual, that shipped with your switch, for further switch
configuration instructions. The following example is from a SunSwitch.
>> Main# cfg
>> Configuration# port
Enter port number: 9
[Port 9 Menu]
.
.
>> Port 9# auto
Current Port 9 autonegotiation: on
Enter new value ["on"/"off"]:
>> Port 9# apply
>> Port 9# save
Features
SBus
Fully compliant with IEEE 802.3z
Full- and Half-duplex gigabit ethernet interface (IEEE P802.3z draft)
Standard Ethernet frame size (1518 bytes)
Dual DMA channels
Reduced interrupt load on system
Hardware assists in generating TCP checksum
Duplex SC fiber connector (850 nm, SX)
25-MHz, 32- or 64-bit SBus
Supports Full Flow Control
Single 1000Base-SX (GbE) port
5.75-inch x 3.25-inch card, compliant with IEEE standard 1496
Developed by Sun Microsystems
off
Chapter 1
Product Overview
3
Need help?
Do you have a question about the GigabitEthernet/S 2.0 and is the answer not in the manual?