Table C-2 Gemtest Options; Table C-3 Gemtest Command Line Syntax - Sun Microsystems GigabitEthernet/S 2.0 Installation And User Manual

gemtest Options
TABLE C-2
gemtest Options
Configuration
Total Packets
Packet size
Loopback
Print_Warning
Processor Affinity
gemtest Command Line Syntax
/opt/SUNWvts/bin/gemtest
-o dev=
,warn=
TABLE C-3
Argument
dev=
tpkts=
pksz=
Internal
lb=
warn=
Note – 64-bit tests are located in the sparcv9 subdirectory: /opt/SUNWvts/bin/
sparcv9/testname. If a test is not present in this directory, then it may only be
available as a 32-bit test.
40 Sun GigabitEthernet/S 2.0 Adapter Installation and User's Guide • September 1998
gemtest Options
Description
Specifies the Port Address, Host ID and Domain Name of the
system under test.
Specifies the total number of the packets to send.
The default number of packet is 1000.
Determines the size (in bytes) of the packets to be
transmitted. 60 <= packet size <= 1514. The default packet size is
1000 bytes.
Determines the external and internal loopback mode. The default
setting is internal loopback mode.
Enables or disables the printing of warning messages. The default
setting is Disable.
Binds the test to a specific processor. If no processor is specified, the
test migrates between processors. This option is only available on
multiprocessor systems.
device n
,tpkts= ,pksz=
Disable
gemtest Command Line Syntax
Explanation
device_name Specifies the device to test such as ge0
n [1..100000], count of packets to loopback
pkt_size [60 ... 1514], packet size in bytes
select internal (or external) loopback mode
Disable enable or disable printing of warning messages
standard_arguments
pkt_size Internal
,lb=