Sun Microsystems GigabitEthernet/S 2.0 Installation And User Manual page 40

Parent = /sbus@b,0
Note – The "name" property in the ge.conf file should be the same value as the
"compatible" property. In this case, the value is SUNW,sbus-gem. See page 7 for
more information about the .properties file.
1. Set the ipg1 and ipg2 parameters for the above devices in the
kernel/drv/ge.conf file.
SUNW,sbus-gem
name = "
reg="0x2,0x100000,0x14,0x2,0x200000,0x9060" ipg1=20 ipg2=10 ;
2. Save the ge.conf file.
3. Save and close all files and programs, and exit the windowing system.
4. If your system doesn't support DR, reboot by typing the init 6 command at the
superuser prompt.
/sbus@b,0
" parent = "
Chapter 3
"
Configuring Driver Parameters 25