Command Line Instructions (Cli) - CAMBRIONIX ThunderSync3-C10 User Manual

5.5.6 Command Line Instructions (CLI)

Command Line Instructions can be used to control and monitor the functions of the hub and
attached devices. To use the command-line interface a serial terminal emulator must be installed on
the host computer. Examples include PuTTy, Serial, ZTerm, and Minicom. If you would like more
information, please look at our more in-depth information here:
Two example commands can be seen below, you can use these commands to check hub information
and health.
Command
system
health
ThunderSync3-C10
Show hardware and firmware information
Show voltages, temperatures, errors and boot flag
www.cambrionix.com/cli
Action
Page 24 of 41