Using Your Thundersync3-C10; Led States; Fan Behaviour - CAMBRIONIX ThunderSync3-C10 User Manual

5. Using your ThunderSync3-C10

In this section, you can find information using your hub in charge or sync application. You can also
find information on managing your hub, changing port modes, connecting multiple hubs to one host
and using Cambrionix Software.

5.0.1 LED States

Your ThunderSync3-C10 has inbuilt LEDs used to show the state of the ports, devices and the power
state. These LEDs can be configured to support your use case; this can be controlled either by using
the API to send commands directly or through separate software. When the hub is powered on all the
available LED's will flash once and then revert to the default behaviour mentioned below.
Colour
Solid Green
Yellow
Red
LED Off

5.0.2 Fan Behaviour

Your ThunderSync3-C10 has an inbuilt fan used to cool the product when internal temperatures rise
above a set threshold. On power up the fan will spin for approximately a second before turning off.
The temperature at which the fan should begin to cool the device is 55 °C, the fan will be at max
speed when the internal temperature reaches 70. Once the ThunderSync3-C10 is below internal
temperature of 55 the fan will switch off.
ThunderSync3-C10
Device connected and port is on
Hub is resetting
Fatal error
No Device is detected
Behaviour
Page 11 of 41