Table of Contents
Advertisement
Modulation
8.11.4
Modulation Source
4FSK uses internal modulation source. The modulating waveform is square.
8.11.5
4FSK Rate
When internal modulation source is selected, press [Mod] >
at which the output frequency shifts between "carrier frequency" and three "hopping
frequencies".
⚫
Use the numeric keypad or direction keys and knob to input the desired rate value.
⚫
The rate range is from 2mHz to 1MHz and the default is 100Hz.
8.11.6
Hopping Frequency
The range of hopping frequency depends on the carrier waveform currently selected.
Refer to "Frequency Characteristics" in Specifications.
Press [Mod] >
input the desired frequency value.
8.12
OSK Modulation
When OSK (Oscillation Shift Keying) modulation is selected, users can configure the
generator to output a sine signal with intermittent oscillation as shown in the figure
below (the carrier waveform is 100Hz and the OSK rate is 1kHz). The start-oscillation
and stop-oscillation of the internal crystal oscillator are controlled by the internal signal
level or signal level from the [FSK/Trig/Sync/Extmod] connector on the rear panel.
When the internal crystal oscillator starts to oscillate, the instrument starts to output the
carrier waveform and when the internal crystal stops oscillating, the output stops.
HDG3000C User manual
54
HopFreq
softkey. Use the numeric keypad or direction keys and knob to
Rate
softkey to set the rate
Copyright © Qingdao Hantek Electronics Co., LTD
EN
Advertisement
Table of Contents
