Haltech TMS-4 Quick Start Manual page 6

TMS-4 OPERATION
Assigning sensors to wheels
Pressure sensors can be re-assigned to any wheel in
the setup menu, which allows users swap wheels and
re-assign sensors without physically swapping parts.
By default sensors are assigned as per the stickers
on the sensors. Sensors can also be turned off in the
software if monitoring that wheel is not required.
Channels
The following data channels are available in both NSP
and ESP software, as shown in this image 
TMS-4 channels can be searched for by using the
keywords "tyre", "tire", and "wheel".
Channels displayed:
• Per Tyre Pressure
• Per Tyre Temperature
• Per Tyre Sensor Voltage
• Per Sensor Pressure
• Per Sensor Temperature
• Per Sensor Battery Voltage
• Air Leak Detected (1 channel covers all 4 tyres)
• Recommended Tyre Pressures
(for logging and display purposes only)
NOTE: The recommended tyre pressures are values defined by
users under the sensor setup and assignment tab of NSP and
ESP software. These figures are only used for the convenience
of display and are NOT used in any calculations.
6