Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Haltech uC-10
Summary of Contents for Haltech uC-10
- Page 1 DISPLAY DASH QUICK START GUIDE...
-
Page 2: Front View
This quick start guide will walk you through the What’s in the box? The full-color TFT screen is optically bonded for installation of a Haltech uC-10 Display Dash into clear visibility, even in bright sunlight, and the a vehicle already fitted with a Haltech ECU or •... - Page 3 DTM-4 connector. read and display data from the vehicle’s OBD- Note: The Haltech WB1/WB2 may need to be externally powered, depending on the ECU and wiring harness used. II system. Apart from being a communications 3.
- Page 4 Display Dash. Follow these steps to install the Haltech NSP software: 1. Download the NSP installer - Go to the Haltech website (www.haltech.com), navigate to the ‘Downloads’ section, and click on the download link.
- Page 5 To set up your Wi-Fi connection, follow these password. steps: NOTE: The Wi-Fi hardware and antenna are 1. Open NSP and connect your uC-10 Display Dash included, but Wi-Fi functionality will not be using the provided USB-C cable. available in the initial release. Update to firmware 2.
- Page 7 PINOUT INFORMATION uC-10 Main connector AMP 34-pin Keyway 2 Wire side view FUNCTION FUNCTION CAN High AVI 1 (Fuel Level) CAN Low AVI 2 +12V switched input AVI 3 Battery ground AVI 4 +5V output AVI 5 (Left Indicator)
- Page 8 Any SPI SPIs are compatible with both digital (hall effect or Pin 2: CAN low uC-10 can be wired to the alternator, serving as a Signal ground optical) and analog (reluctor) sensors. They have Example Load (Fan) Pin 3: Switched +12v...
- Page 9 Button ground (Pin 14) Used with the standard dash mount, this allows AVI 9 (Pin 17) you to install the uC-10 display dash onto a roll Button 2 (Red) Handbrake Signal cage or steering column with an outer tube Ground diameter of 31.75mm (1.25”).
-
Page 10: Specification
Always disconnect the battery when doing electrical work on your vehicle. Avoid sparks, If the Haltech product is found to be defective as mentioned above, it will be replaced or open flames or use of electrical devices near flammable substances. Do not run the en- Female RP-SMA (Wi-Fi Antenna connection) repaired if returned prepaid along with proof of purchase. - Page 11 11/2024 Haltech Australia Haltech USA East Haltech UK 17 Durian Place, 750 Miles Point Way, Unit 1, Miras Business Estate, Wetherill Park NSW 2164 Lexington, KY USA 40510 Keys Park Road, Hednesford, Australia Phone: (888) 298 8116 WS12 2FS Email: usa@haltech.com...
Need help?
Do you have a question about the uC-10 and is the answer not in the manual?
Questions and answers