Table of Contents
Advertisement
CONFIGURATION
The DSU III TDM is configured from the front panel. The DSU III TDM
contains four different user profiles (sets of configurations options) that
are stored in read-only memory. These profiles are listed in the appendix
Configuration Profiles on page B-1. The unit is shipped from the factory with
profile 1 (default configuration) loaded into the nonvolatile configuration
memory. If profile 1 matches the desired system requirements, then no
additional configuration is required to put the unit into service. If profile
1 does not match the desired system requirements, modify the default con-
figuration or select another profile more closely matching the desired con-
figuration and modify.
When a new profile is loaded or the existing profile is modified, it is stored
in the nonvolatile configuration memory. The DSU III TDM is then con-
figured with that profile every time power is turned on or the unit is reset.
See the chapter Manual Command on page 10-1 for information on loading
default configuration profiles.
Ports 1 to 4 are initially configured as follows
DTE Rate .........................................................................DTE 9.6K
Data Format ..............................................................Synchronous
CD Option.......................................................................... Normal
CS Option.......................................................................Follow RS
SR Option ................................................................Off OOS Only
Loop Rate ........................................................................... 56 kbps
Clock Source ......................................................... From Network
Test Timout....................................................................................0
Remote Digital Loopback (RDL) ........................ RDL Accepted
61200063L1-20
DSU III TDM User Manual
Chapter 2. Installation
2-5
Advertisement
Table of Contents
Troubleshooting
