Advertisement
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS Table
Flash count - Wireless mode
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a
). The
WR12 repeater
itself must be in a position where the signal level is at least sufficient.
R30"
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the
The link will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary to force the
operation. In such cases, put the device in STANDBY mode, then run the TEST again (
NOTE: The display equipped datalogger (
6. Stand-alone USB datalogger installation.
Install the datalogger in appropriate place.
If the sampling process has not yet been activated, you can start it through the WineCapKey.
Bring it closer to the sensitive point, wait for 2 flashes (
sampling according to your settings through your PC.
Through the
WineCapKey
is possible to ask for the status, bring it close to the datalogger for 1 flash (
STAND-ALONE MODE STATUS Table:
Flash count - Stand-alone mode
CAPETTI ELETTRONICA s.r.l. - Strada Stratta, 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail
info@capetti.it
5 green flashes
4 green flashes
3 green flashes
2 amber flashes
1 red flash
1 red flash 2" long
2 red flashes 2" long
Short-long-short red
flashes series
Picture 5 - Status table - Radio signal quality
WR12 repeater
) is recommended, to verify the signal quality during devices installation.
WD04T
) (
TEST
refer to
1 green flash 2 seconds long
2 red flashes 2 seconds long
Sequence of red flashes: short, 2
seconds long, short
Picture 6 - Stand-alone datalogger status
- web
www.capetti.it
WSD12T-CO
User Manual
Status/Radio signal quality
Insufficient
OUT OF RANGE
Network searching
FACTORY RESET
Device not enrolled
should be put between (
refer to
refer to
"WineCap System - User Manual
) and remove. The datalogger begins
Picture 4 - Commands table
ACTIVE
STANDBY
FACTORY RESET
INVALID datalogger clock!
PC connection required
Excellent
Good
Fair
Sufficient
STANDBY
"WineCap System - User Manual
WR12
repeater.
).
R30"
) and remove it.
STATE
STATUS
WA0241E_WSD12T-CO_User Manual_R02
V4.8
Advertisement
