Important Information; Installation Data; Safety Information - Nibe VVM 500 User Manual

Important information

Installation data

Product
Serial number
Installation date
Installer
No. Name
1.1 temperature (heating curve offset)
1.9.1 heating curve (curve slope)
1.9.3 min. flow line temp.
Accessories
Serial number must always be given.
Certification that the installation is carried out according to instructions in the accompanying installer manual and applicable regulations.
Date _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Safety information

This appliance can be used by children
aged from 8 years and above and per-
sons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning use
of the appliance in a safe way and under-
stand the hazards involved. Children shall
not play with the appliance. Cleaning and
user maintenance shall not be made by
children without supervision.
This is an original manual. It may not be
translated without the approval of NIBE.
Rights to make any design or technical
modifications are reserved.
©NIBE 2022.
VVM 500 must be installed via an isolator
switch. The cable area has to be dimen-
sioned based on the fuse rating used.
4 Chapter 1 | Important information
VVM 500
Signed ____________________________________________________________
Default settings
0
9
20
If the supply cable is damaged, only NIBE,
its service representative or similar author-
ised person may replace it to prevent any
danger and damage.
Do not start VVM 500 if there is a risk that
the water in the system has frozen.
System Max
pressure
Heating me- 0.3 MPa
dium (3 bar)
Domestic 1.0 MPa
water (10 bar)
Set
Min
0.05 MPa
(0.5 bar)
0.01 MPa
(0.1 bar)
NIBE VVM 500