When Replacing The Board Other Than The Above - Sony VPL-VW760ES Service Manual

When the adjustment data cannot be extracted
1. Obtain the data (UF/Gamma/UGM/SLC/PWM/DWEC/BPC/CLK/WBMatrixTable/ColorSensorMa-
trix2Table/UFGainMatrixTable/OptUnit2 (CSC)/OptUnit (panel chiral/lens shift/lens zoom/panel
alignment/uniformity)/LaserUnit/serial) via server.
t
Regarding how to obtain the server data, contact your local Sony Sales Office/Service Center.
2. Write down the values of Other:83 DigiPote 1 of DeviceMenu.
3. Write down the values of Other:84 DigiPote 2 of DeviceMenu.
4. Replace the QE board. (Refer to Section 1-5-18.)
5. Write the data obtained in step 1 from the USB memory. (Refer to Section 3-3.)
6. Enter the service mode and execute "save enable" in calibration. (Refer to Section 2-4.)
7. Set Other:83 DigiPote 1 of DeviceMenu to the value written down in step 2.
8. Set Other:84 DigiPote 2 of DeviceMenu to the value written down in step 3.
9. Set the Display Engine:2 UF SW of DeviceMenu to 1.
10. Perform "Save to memory".

2-3-5. When Replacing the Board Other Than the Above

No adjustment is required.
VPL-VW760ES
2-7 (E)