Sony VPL-VW760ES Service Manual page 42

23. Connect the power harness to the CA and CB boards.
24. Attach the fan bracket.
25. Connect the fine-wire coaxial relay boards (FX boards) to the three fine-wire coaxial cables, then
connect them to other fine-wire coaxial cables.
t
Tapes for identifying R (red), G (green), and B (blue) are wound on each cable.
26. Connect the other of the fine-wire coaxial cables to the CA and CB boards.
27. Attach it with the three screws while striking the shade plate assembly (Reta Ajst) in the direction
indicated by arrow (A).
n
. Take care that the flexible wiring board of the panel and the projector tool FPC kit are not removed.
. Be careful not to damage the flexible wiring board of the panel and the projector tool FPC kit when
attaching the shade plate assembly (Reta Ajst).
Viewed on arrow B
1-34 (E)
Shade plate
assembly (Reta Ajst)
(A)
Fan bracket
Bosses
1: Fine-wire coaxial relay board (FX board)
2: Fine-wire coaxial cable
Power block
PSW
3 8
Shade plate assembly (Reta Ajst)
Relay connector
Blue tape
Red tape
Green tape
1
2
2
1
B
PSW
3 10
2
1 Boss holes
CN1000 (CB board)
CN1000 (CA board)
Blue tape
2
Red tape
2
Green tape
2
VPL-VW760ES