Adjustment When Replacing The Sy-378 Board Or Ic1002 To Ic1004 - Sony SRX-R320 Service Manual

In the case of 3D
1. Check that the image position is appropriate with respect to the screen by referring to "1-7. Masking
Adjustment 2" in Installation and Service Manual of LKRL-A002/A003.
2. When it is deviated in the horizontal (H) direction, start the SRX Controller and perform the follow-
ing adjustment.
(1) Click the "FUNCTION MEMORY" tab.
(2) Select FUNCTION setting, and then click the [RECALL] button.
(3) Click the "FUNCTION FOR 3D" tab.
(4) Click the [SELECT] button in the "POSITION ADJUST" menu.
The "POSITION ADJUST" window is displayed.
(5) Adjust the image position to the screen using "H Adjust" of "L/R SYNCHRONIZE" in the
"POSITION ADJUST" menu.
(6) Click the [CLOSE] button.
(7) After checking that there is no problem including the masking, click the APPLY button in the
FUNCTION MEMORY window.

2-6. Adjustment when Replacing the SY-378 Board or IC1002 to IC1004

It is required to read the date written in IC1002 to IC1004 before replacing the SY-378 board or IC1002 to
IC1004 on the SY-378 board, and write it in IC1002 to IC1004 after replacement.
Required equipment
. NVMMemoryUtility.exe or NVMBackUp Tool
n For use of the NVMBackUp Tool, refer to the operating specifi cation supplied with the tool.
. PC (Refer to Section 2-1.)
. RS-232C cable or Ethernet cable
Procedure
1. Connect each equipment according to Section 2-2.
n
Select either RS-232C or Ethernet connection. When the unit is connected to SMS (Screen Manage-
ment System) with Ethernet, disconnect the SMS connection.
2. Install SRX Service Tool. (Refer to Section 2-3-2.)
3. Make this unit standby state. (Refer to Section 2 in Installation Manual.)
n Quit SRX Controller if it is activated.
4. Double-click "NVMMemoryUtility.exe".
The following window is displayed.
2-6 (E)
[Connect] button
Fig. 2-6a
SRX-R320