Others; Note When Replacing The Main Board - Sony VPL-ES7 Service Manual

2-7. Others

2-7-1. Note When Replacing the Main Board

The new Main board of VPL-ES7 is shipped with the 3D Gamma set to OFF.
After replacing the Main board and upon completion of adjustment, set the 3D Gamma setting to ON.
For the VPL-EX7/EX7IN/EX70, the following work is not necessary since the projector is shipped from
the factory with the 3D Gamma set to ON.
1. Enter the Factory Mode and display page 1.
2. Move the cursor to DELUT SW.
3. Operate the [*] key and set the 3D Gamma setting to ON.
P1-1 CXD9809-page1
TGHST Phase Hi 0
TGHST Phase Lo 111
SHSH1 31
TGHST Position 18
DEHPF On ON
DEHPF AAC ON
DEHPF TAP 3
DEUSC On OFF
3D GammaSubCont 8
3D GammaSubBrt 50
DELUT SW OFF
DEUF SW ON
How to Enter the Factory Mode
1. Power on the projector.
2. Push the switches on the remote controller or controller panel as below.
[Enter] → [Enter] → [&] → [PIC|MUTING] key
3. Factory mode menu will appear on the screen.
n
In the factory mode, do not enter any items except the specifi ed one because the data cannot be returned
back to the original value if it is changed once.
VPL-ES7
2-9