Table of Contents
Advertisement
PROGRAM SCHEDULED EVENTS (CONT.)
PROGRAM SCHEDULED EVENTS (CONT.)
Press ▲/ ▼to select a desired Heat Setpoint for the
currently selected scheduled event (Occupied1).
i
Note: To return to the menu of scheduled
events and continue programming, select
Next
after Step 11.
i
Note: To program 5-1-1 day or 5-2 days,
see Service Menu 100 (See the Installation
Guide). Block-programmed days flash as
a group.
8.
Press ▲/ ▼ to select a scheduled event
(e.g, Occupied1, etc.), then Next.
9.
Press ▲/ ▼to schedule start time for
event (in 15-minute periods), then Next.
Now select a Heat Setpoint and/ or Cool
Setpoint for the scheduled event (available
options depend upon system type selected).
10. Press ▲/ ▼to select desired Heat
Setpoint, then press Next.
11. Press ▲/ ▼to select desired Cool
Setpoint, then press Next. Note: The next
event (e.g., Unocc1) begins flashing after
Next
is selected. Complete steps 3-11 for
each scheduled event.
Done
12. Press
to exit schedule mode.
Note: Pressing
show
Select Day
Go Back
after step 11 will
on display.
17
Advertisement
Table of Contents
