Emerson CARRERA GRANDE ECO CF788AP01 Owner's Manual page 19

8. Wall Control Installation
3-Way Installation
(One fan controlled by two different wall controls)
(See Figures 30 and 31.)
8.4
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker or Fuse Box before attempting to
install the Ceiling Fan Wall Control into the Outlet Box
(Figure 30).
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
8.5
At all Wall Box locations, remove Faceplates and
Screws from Existing Controls.
Pull Controls out from Wall Boxes and determine which
Wall Box contains the "HOT" Wire and which Wall Box
contains the "LOAD" Wire.
Also, identify Traveler Wires which are common to both
Wall Boxes.
Disconnect Wires from Existing Controls ONLY.
Do not attempt to disconnect any Wires not already
connected to Existing Controls (Figure 31).
(Continued)
Figure 30
SCREWS
Figure 31
Please contact 1-800-654-3545 for further assistance
19
MAIN FUSE BOX
OUTLET
WALL BOX
SWITCH
FACEPLATE
emersonfans.com
ETL Model No.: CF788