The Wgx102 Front Panel - NETGEAR WGX102 Reference Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102

The WGX102 Front Panel

The front panel of the WGX102 Wall-Plugged Range Extender contains the status lights described
below.
Figure 2-1: WGX102 Front Panel
You can use the status lights to verify connections. Viewed from top to bottom, the table below
describes the lights on the front panel of the range extender.
Table 2-1. Status Light Descriptions
Label
Power
HomePlug — AP Mode
Internet — Router Mode
Wireless
Introduction
Activity
On Green Solid Power is supplied to the WGX102.
Blink Power on self test.
Off Power is not supplied to the WGX102.
On The HomePlug port (or Internet port in Router Mode) has
detected a link with an attached device.
Off No devices are attached on the Powerline network.
On The Wireless port is initialized and the wireless feature is
enabled.
Blink Data is being transmitted or received by the wireless port.
Off There is a problem with the device. See
"Troubleshooting".
September 2004 202-10042-01
Description
Chapter 9,
2-5