Verifying Tcp/Ip Properties For Macintosh Computers - NETGEAR WGX102 Reference Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102
MacOS X
From the Apple menu, choose System Preferences, then Network.
1.
2. If not already selected, select Built-in Ethernet in the Configure list.
3. If not already selected, Select Using DHCP in the TCP/IP tab.
4. Click Apply Now.

Verifying TCP/IP Properties for Macintosh Computers

After your Macintosh is configured and has rebooted, you can check the TCP/IP configuration by
returning to the TCP/IP Control Panel. From the Apple menu, select Control Panels, then TCP/IP.
The panel is updated to show your settings, which should match the values below if you are using
the default TCP/IP settings that NETGEAR recommends:
• The IP Address is between 192.168.0.2 and 192.168.0.254
• The Subnet mask is 255.255.255.0
• The Router address is 192.168.0.1
If you do not see these values, you may need to restart your Macintosh or you may need to switch
the "Configure" setting to a different option, then back again to "Using DHCP Server".
C-20
September 2004 202-10042-01
Preparing Your Network