Reference Manual for the Double 108 Mbps Wireless Firewall Router WGU624
•
Shared Key Authentication requires that the station and the access point have the same WEP
Key to authenticate. These two authentication procedures are described below.
Open System Authentication
The following steps occur when two devices use Open System Authentication:
The station sends an authentication request to the access point.
1.
The access point authenticates the station.
2.
The station associates with the access point and joins the network.
3.
This process is illustrated in below.
Authentication Steps
1) Authentication request sent to AP
3) Client connects to network
Client
attempting
to connect
Figure 9-4: Open system authentication
Shared Key Authentication
The following steps occur when two devices use Shared Key Authentication:
The station sends an authentication request to the access point.
1.
The access point sends challenge text to the station.
2.
The station uses its configured 64-bit or 128-bit default key to encrypt the challenge text, and
3.
sends the encrypted text to the access point.
The access point decrypts the encrypted text using its configured WEP Key that corresponds
4.
to the station's default key. The access point compares the decrypted text with the original
challenge text. If the decrypted text matches the original challenge text, then the access point
and the station share the same WEP Key and the access point authenticates the station.
D-4
Open System
2) AP authenticates
M-10153-01
Access Point (AP)
IN TER N ET
W LA N
LO CA L
MODEL
FVM318
Cable/DSL
ProSafeWirelessVPN Security Firewall
LNK
100
PWR
TEST
ACT
Enable
LNK/ACT
1
2
3
4
5
6
7
8
DLS modem
Wireless Networking Basics
Cable or