Viewing A List Of Attached Devices - NETGEAR WGX102 Reference Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102

Viewing a List of Attached Devices

The Attached Devices menu contains a table of all IP devices that the range extender has
discovered on the local network. From the main menu of the browser interface, under the
Maintenance heading, select Attached Devices to view the table, shown below.
Figure 6-7: Attached Devices menu
For each device attached to the WGX102, the first table shows the IP address, NetBIOS Device
Name (if available), and Ethernet MAC address. Note that if the range extender is rebooted, the
table data is lost until the WGX102 rediscovers the devices. To force the range extender to look for
attached devices, click the Refresh button.
The second table shows the MAC (Media Access Control) Address and Data Rate for each
HomePlug PC or device on the HomePlug network detected by the WGX102. You cannot change
any of the values shown here. To update this list and to show the current attached devices, click the
Scan Powerline Network button.
Maintenance 6-9
September 2004 202-10042-01